On Board Converter To Use with AGM Batteries
Updated 07/15/2020 | Published 11/22/2019
Products Featured in This Question
Question:
I have a Inteli-Power PD9100 Converter which is used to charge my batteries as well as supply coach accessories. I am using AGM batteries and this charger isnt powerful enough to supply the 14.7 absorption needed for bulk phase charge. Is there a inverter designed for AGM batteries?
asked by: Steve E
Expert Reply:
I recommend looking at the Go Power RV Converter and Smart Battery Charger # 34266912 which has a maximum output of 14.4v and is designed to work with AGM batteries. This is the most powerful converter and smart battery charger we have and it is rated much higher than the 13.6v max on the Progressive Dynamics 9100 series converters like the # PD9130.
Per the instructions (included) you will need to remove your existing converter, as it is not designed to work on conjunction with that system.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Go Power RV Converter and Smart Battery Charger - 12V - 100 Amp
- Search Results: pd9360
- Search Results: trailer tpms
- Search Results: cummins onan generators
- Search Results: tpms sensor accessories and parts
- Search Results: trailer suspension parts
- Search Results: keyless entry latch rv door locks
- Shop: Progressive Dynamics 9300 Series RV Converter Charger - 12V - 60A
- Q&A: What Batteries Is Progressive Dynamics PD9245C Converter Compatible With
- Shop: Go Power RV Converter and Smart Battery Charger - 12V - 45 Amp
- Video: Go Power RV Converter and Smart Battery Charger Spec Review
- Shop: TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster - 4 Tire Sensors
- Q&A: Will My Converter/Charger Work With A 100ah AGM Battery?
- Video: Review of the TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster
- Shop: TorkLift Cannon Hitch Extension - 3" Ford Super Duty Factory Hitch - 36" Long
- Q&A: Does Progressive Dynamics PD-9260 Converter & Battery Charger Work With Gel Batteries
- Shop: MB Sturgis Propane Adapter Hose - Model 250 Quick-Disconnect x Disposable Cylinder Port - 4'
- Shop: Bauer Products Camper Door Lock - White
- Video: Ultimate Overview of the MB Sturgis Propane Adapter Hose
- Video: What to Know About the Bauer Products Camper Door Lock
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Shop: Camper Tie-Downs
- Q&A: Recommended Frame Mounted Torklift Camper Tie Downs for a 2015 Ford F-250
- Shop: Brake Controller
- Search Results: rv converters
- Video: Mount: Go Power RV Converter and Smart Battery Charger on a 2002 Coachmen Cross Country Motorhome
- Q&A: Converter to Replace the Magnetek Series 900 Model 950
- Article: How to Mount a Truck Bed Camper
- Shop: Trailer Wiring
Peter G.
7/15/2020
I have a 2007 Holiday Rambler travel trailer. the original converter was designed for marine batteries, I installed two six volt AGM batteries. The original converter is a TP3 SS Atwood 55 amp unit. It is not appropriate for newer AGM type batteries as it overcharges them. Will this 12V - 60 amp unit work well for me in order to solve that issue? The trailer usually uses 30 amp service, not 50. There are four wires that are used to install the original. How does this new unit install with a standard three prong plug? Is there tech service I could contact if I have install questions? Thank you.