Replacement Landing Gear Extend/Retract Switch for Keystone Montana Trailer
Updated 11/12/2019 | Published 11/11/2019
Question:
Im looking for the EXT/RET switch for a 2009 Montana Landing Gear. Its 6 pin and Im not finding it. Any suggestions?
asked by: Ccb
Expert Reply:
The extend/retract switches for landing gear legs are more or less universal so I recommend the Replacement Switch for Stromberg Carlson Electric Landing Gear part # LG-145236. I am not sure why you have a total of six pins but this is sorta irreverent as a landing gear motor is only going to have two wires, power and ground. If the switch has any lights then that may then be why other pins are present but nonetheless you can still use the above and just wire it using the following diagram. If you have a dual motor landing gear setup then you will simply need to use two switches.
Product Page this Question was Asked From
Replacement Switch for Stromberg Carlson Electric Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Availability of Auto Start System for Cummins Onan QG 5500 Generator
- Q&A: Is Onan 11,000-Watt Tri Fuel Portable Generator Capable of Running Two 15k BTU AC Units
- Q&A: Is Onan 11,000-Watt Tri Fuel Portable Generator Quiet Enough for Campgrounds
- Q&A: Solution for Needing Replacement Atwood Slide Out Switch AT141-134
- Q&A: 5th Wheel Landing Gear Motor Comparison for Part Number From LCI 142178
- Q&A: Landing Gear Motor Replacement for 065-041012-01 with 7140 RPM
- Article: Best Landing Gear
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box