Westin Sportsman Grille Guard Hardware Kit that Fits 2004 Dodge Ram 1500  

Yes, the package contents for the Replacement Hardware Kit for Westin Sportsman Grille Guard #40-120PK are as pictured. This kit will work to install the Westin Sportsman Grille Guard #40-1205 that is a confirmed fit for your 2003 Dodge Ram Pickup.…

We do offer the replacement hardware kit part #40-120PK.

We have one Westin grille guard that is confirmed to fit the 2004 Dodge Ram 1500 which is the #40-1205. Assuming you have this grille guard the correct hardware is the Replacement Hardware Kit for Westin Sportsman Grille Guard 40-1205 #40-120PK.

For your 2007 Ram 3/4 ton, I'd recommend the Curt #C31017 which would mount to the underside of the frame members and would have the receiver tube sitting directly under the front bumper. I spoke with my contact at Draw-Tite who confirms that…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

There's a few differences. • The Curt #C31017 is manufactured in the US, while the Draw-Tite #65046 is manufactured in Mexico. • When installed, the Curt hitch will sit higher on the vehicle for more ground clearance. The underside of the…

Let's start at the brake assemblies/hubs on your new gooseneck trailer. The two wires coming from each assembly look exactly as they should. One wire will ground to the trailer frame and the other wire will attach to the brake output wire. The…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Your slide-in truck camper does not have electric brakes so the blue brake circuit wire from its 7-way connector is not used. All other lighting functions as well as 12V auxiliary power will be maintained on the other circuits. Please refer to the…

I contacted my Curt Manufacturing rep, who tells me the total drop of their #C31017 is 4-1/4 inches. The drop is the distance from the top surface of the mounting flange that would sit flat against the underside of the frame members to the lowest…

Yes, the Curt front hitch part #C31017 that you referenced will fit your 2005 Dodge Ram 2500 Power Wagon. We checked with Curt and the only version of the 2005 Ram 2500 or 3500 that this hitch won't fit is the 3500 Laramie.

The Draw-Tite Front Mount Trailer Hitch Receiver part #65046 is designed to sit flush with the underside of the lower bumper fascia skirt on a 2003 Dodge Ram 3500. I have attached a photo which shows this. It sits as close to the underside of the…