110 Rough Cut Opening Needed to Install Ventline Roof Vent w/ 110V Fan # V2128SP-01
Updated 09/30/2019 | Published 09/28/2019
Products Featured in This Question
Question:
What is the rough opening for the 110v power roof fan?
asked by: Larry S
0
Expert Reply:
The Ventline Roof Vent w/ 110V Fan # V2128SP-01 that your referenced requires the standard rough cut opening right at 14-1/4 inch square. This is the only option that uses 110 volt power as well. I attached a review video for more info as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ventline Roof Vent w/ 120V Fan - Manual Lift - 14-1/4" x 14-1/4" - White - Polar Trim
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 120V Fan
- Plastic and Metal
- White
- Ventline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Front Hitch for a 2023 Ford Transit T250 Eco-Boost
- Q&A: RV Roof Vent that can Be Use 120 AC Power
- Q&A: Dimensions of Polar # PLR1902 Steel Trailer Ramp Spring
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Can You Convert Tie Down Engineering LP8500 from Disc to Drum
- Q&A: Replacement for a TDE LP8500 Boat Trailer Acuator
- Q&A: Can A Spare Tire Be Mounted Above/On Top Of The Wheel Well Of A Cargo Trailer?
- Q&A: Option For Replacing Atwood 8525-IV-DCLP Furnace
- Article: How to Replace an RV Roof Vent Cover
- Article: How to Replace or Install an RV Roof Vent
- Article: How Much Solar Power Do I Need For My RV?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Hitch Mounted Cargo Carrier Information
- Article: Trailer Wiring Diagrams