Can Welding On Stabilizer Jacks to RV Damage Electronics
Published 09/18/2019
Question:
I wanted to know if welding the jack legs on would create any issues with electric? I have a 2013 Shasta Oasis
asked by: Crystal
0
Expert Reply:
Arc welding can possibly damage electrical devices on the RV so if this is what you plan to do I'd recommend disconnecting the wiring from the batteries etc. A safer method would be welding with a torch. Welders typically say just to disconnect the battery and connect the ground as close to the weld as possible and you'll be fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Leveling Scissor Jack - 24" Lift - 5,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Scissor Jack for 2014 R-Pod Camper
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Leveling Jack Options For A 2020 Forest River Rockwood Mini-lite
- Q&A: Comparing 4.80-12 and 155/70R12 Tire Dimensions
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: Dimensions of Leveling Scissor Jack # JSC-24-IND
- Q&A: Recommended Replacement for a Domar Scissor Jack
- Q&A: What are the Hole Pattern Dimensions for the etrailer Scissor Stabilizer Jack - 24" Lift 2,500 lbs?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: RV Sway Control, Stabilization, and Suspension Enhancement