Replacement Light Lens for 2015 Palomino Solaire 147X

Question

Question:

Hi Jameson Attached are pics of the light for my 2015 Palomino Solaire 147x. Thanks

asked by: Jon B

0

Expert Reply:

If I can see a picture of the porch light and base I might be able to identify it. Otherwise I don't have a way to look it up by the trailer info you listed.

expert reply by: Jameson C

0

click to enlarge

Jon B.

10/21/2019

Hi Jameson Attached are pics of the light for my 2015 Palomino Solaire 147x. Thanks

Jameson C.

10/21/2019

Thanks for the picture! From that I can tell you have the Porch Light # RVPL7CB which means the lens you need is the # APL5CB.

Answer 1

Hey Dusty, I emailed the manufacturer to get the dimensions you are looking for on the #ABS56FR and the overall length is 5-5/32” with the hole spacing of 3-29/32” center to center.

view full answer...

Answer 2

I see the door thickness picture you attached but that's the only picture that made it through. The part #295-000019 is a standard RV style latch that can fit door thicknesses of up to 1-1/2 inches so this would work but it requires a cut out of…

view full answer...

Answer 3

Hi Jeff, What you have there is a Fastec (FIC) entry door latch on your trailer, and the good news is we can get you a replacement with the following: - Global Link RV Entry Door Locking Latch Kit #295-000019

view full answer...

Answer 4

Essentially you need to measure the height of the garnish from above the lip to the very top. If you can't find one that fits exactly you can get a garnish that's too large and cut it down to size.

view full answer...

Answer 5

The most popular RV porch light we have is the RV Rectangular Porch light part #RVPL1C which we've sold quite a few of and have not had any reports back of leaks or rust.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Light Lens for 2015 Palomino Solaire 147X

Product Page this Question was Asked From

Continue Researching