What Causes Grease Gun to Get Stuck on Grease Fitting
Published 09/12/2019
Question:
the greasegun connector willnot come off of greasefitting
asked by: D C
0
Expert Reply:
Grease guns get stuck on fittings due to clogged zerk fittings which don't let the grease pass through and cause a pressure build up that prevents them from releasing. So to get it unstuck unscrews the hose or hardline from the gun which will release the pressure and allow it to come off. You do need to clear out the zerk fitting though. There are solvents for this as well as grease gun like devices (we don't carry) that insert a high pressure solvent to break it up.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - 02475
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.25 Inch I.D.
- Bearing 02475
- Race 02420
- 8000 lbs Axle
- etrailer
more information >
Continue Researching
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Q&A: How Many Additional Panels Can Be Added To The Rich Solar RV Solar Charging Kit RS37VR
- Q&A: What is the Four Bolt Brake Mounting Flange for 8,000 Lb Axles
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Repair Kit for etrailer Ram Jack # TJD-8000S
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: What is the Difference Between the Dexter 010-036-00 and the Timken TMK98ZR Grease Seals?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Mount a Truck Bed Camper
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: How to Replace a Rubber RV Roof
- Article: Determining Trailer Tongue Weight