Accessing Brake Stop Lamp Switch to Flat Tow 2007 Chevy Malibu
Updated 08/30/2019 | Published 08/29/2019
Products Featured in This Question
Question:
Cold wire of brake light switch on a 2007 Chevy Malibu?
asked by: Cameron
Expert Reply:
I'm assuming that you're wanting to flat tow the vehicle. Rather than using the # RM-88400 on the 2007 Malibu, Roadmaster instead recommends using the stop light switch kit, part # RM-751210 if the vehicle has the optional adjustable pedals or # RM-751210 if the vehicle does not have that option.
According to the owner's manual, before flat towing the ignition sensor fuse needs to be removed. The fuse is located on the passenger side of the center console in the location shown in the photo I've provided. A roadmaster Fuse Master, part # RM-76511 will allow you to disconnect the fuse with a flip of a switch.
Product Page this Question was Asked From
Roadmaster Brake-Lite Relay Kit for Towed Vehicles
- Flat Tow Brake System
- Brake Light Relay
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Flat Tow Set Up for a 2026 GMC Canyon AT4
- Q&A: Recommended Flat Towing Parts for a 2026 Ford Maverick Hybrid
- Q&A: Flat Tow Setup for 2018 Ford Expedition Max
- Q&A: Is Demco Stay IN Play DUO Inline Air Pressure Regulator Needed For 2025 Ford Maverick Hybrid
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Q&A: Recommended Parts for Flat Towing a 2023 Lincoln Nautilus
- Q&A: Recommended Safety Cables and Attachment Point Guidance for Blue Ox Off-Road Bumper Adapters
- Article: Must-Have Flat Towing Components
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose a High-Low Adapter
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)