Is Bleeding The System Necessary When Installing Lippert Ground Control Leveling System
Updated 08/19/2019 | Published 08/17/2019
Question:
Replace a motor in my 5 wheel got the part not sure if i need to bleed the system also
asked by: Shirley
0
Expert Reply:
The included video is almost 30 minutes and is very detailed. It walks you through the entire installation process for the Lippert Ground Control # LC675817 leveling system. This leveling system is self bleeding but Lippert does recommend running it 3-5 times after installation to purge any air from the system.
expert reply by:
Patrick R
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Will The Lippert Ground Control 3.0 Leveling System Stabilize A Trailer Better Than Scissor Jacks
- Q&A: Middle Jack Isn't Working on a Lippert 3.0 LC675817
- Q&A: Correct Replacement Legs for Lippert Ground Control 3.0 Leveling System - 6 Point
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Leveling System Compatible with 42 Foot 5th Wheel Trailer
- Q&A: Which Reese Goose Box Fits in Place of Lippert 1116 Pin Box
- Q&A: Dimensions of Reese RP94716-61301 Goose Box 5th Wheel to Goosneck Hitch Adapter
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Sidewinder with Rotating Turret for Short Bed Pickups