Does Westlake ST205/75R14 Tire And Wheel Come Balanced

Question

Question:

Does this tire and rim package come pre-balanced for high speed or will I need to take them somewhere to have that done?

asked by: George R

0

Expert Reply:

The Westlake ST205/75R14 Radial Tire w/ 14" Wheel # LH37VR does not come balanced but this is certainly something you could have done at a local tire shop if desired. Typically though trailer tires don't need to be balanced like standard passenger vehicle tires and doing so may not provide any benefit.

This Westlake tire does have a maximum speed rating of 75 mph but the tire and wheel doesn't need to be balanced to maintain this rating.

expert reply by: Chris R

0

Answer 1

You'll want to keep your 205/75-14 Load Range C tires fully inflated to the 50 psi pressure rating listed on the sidewall. The tires will only have the stated capacity when fully inflated. If they are not fully inflated, the tire's load…

view full answer...

Answer 2

The recommended tire pressure is the max psi listed on your tire. For example, the Westlake ST205/75R14 Radial Tire #LH37VR has a max psi of 65 listed on the tire. This will be filled when the tire is cold.

view full answer...

Answer 3

Trailer tires should always be inflated to the maximum psi indicated on the tire sidewall. This is because trailer tires are built with a thicker sidewall than passenger vehicle tires to handle more vertical load. If under inflated the thicker…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Does Westlake ST205/75R14 Tire And Wheel Come Balanced

Featured Help Information

Miscellaneous Media

Continue Researching