Female Connector that Matches PL-3 Connector # A45PMB
Updated 07/31/2019 | Published 07/30/2019 >
Products Featured in This Question
Question:
I am wiring some two-circuit sealed lights which dont come with connectors or plugs, just 3 bare wires. Do you have a female matching pigtail to this plug which I can use to build a wire harness for my dual function lights?
asked by: Steve S
0
Expert Reply:
Yes, we have the part # AL145PWTB which has the correct female connector to match the part # A45PMB.
The extra 3 pin connector on this could be cut off and not used as needed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
3-Wire Pigtail for Optronics Trailer Lights - Weathertight Plug - 10" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Three Wire
- Straight Pigtail
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Hub Grease Seal for TCM 17255TB Seal
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Q&A: Will Aluminum Transition Plate Bend On Enclosed Trailer When Loading Heavy Zero Turn Mower?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Q&A: Which Pigtails Are Needed For The GloLight LED Trailer Light STL201RFMB?
- Q&A: What Size Hole is Needed to Mount the Optronics Tail Light # ST33RB
- Q&A: What is Backspacing of Trailer Wheel and Tire # TA87VR
- Article: Trailer Lighting Requirements
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires

