Can the Tow-Rax Removable Wheel Chock be Installed on 5/8" Thick Plywood Floor
Updated 07/30/2019 | Published 07/28/2019
Products Featured in This Question
Question:
Looking to install 2 of these wheel chocks in my toy hauler travel trailer. The floor is made of the chopped up recycled ply wood, probably 5/8” thick. Is there a reason for me to be concerned about these anchors pulling through? Only securing a couple motocross bikes, not full dresser Harley’s.
asked by: Kris F
Expert Reply:
I reached out to my contact at Tow-Rax who said that the Removable Wheel Chock # TWSPWC will work great for your application. Please note though that the wheel chock isn't load bearing so you will need to secure your motocross bikes with ratchet straps like part # IMF12636.
Product Page this Question was Asked From
Tow-Rax Removable Wheel Chock w/ Wood Screws - 6-1/2" Wide Tires - Tubular Steel - Chrome
- Wheel Chocks
- Wheel Chock
- Motorcycle
- Steel
- 1 Chock
- Chrome
- Tow-Rax
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Do You Have the Instructions and User Manual for the Advent Air Low Profile RV Air Conditioner?
- Q&A: Biker Bar For The B&W Motorcycle Tie-Down System for Trailers
- Q&A: Is 3/4 Inch Plywood Floor Adequate for D-Ring Tie Down Anchors with Backing Plate for 3,000 lb Car
- Q&A: Recommendation to Convert Generator Power to 12V 7-way Trailer Connection
- Q&A: What Wiring Options Are Available To Power The Bulldog Powered Trailer Jack
- Q&A: Bearing Kit for Lippert 4,400 lb Trailer Axle
- Q&A: Recommended LED Clearance Light that is Red and Amber
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Determining Trailer Tongue Weight
- Article: What To Look For When Buying Ratchet Straps
- Article: How to Measure for Trailer Hitch Drop
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Where to Position the Trailer Axle?
- Article: Trailer Maintenance Schedule