What Might Cause 12 Volt 7-Way Circuit to Blow When Using Powered Trailer Jack
Published 07/29/2019 >
Products Featured in This Question
Question:
Jameson thanks for the feedback I am going to replace the unit with a manual tongue jack I appreciate the help
asked by: Lee B
0
Expert Reply:
Is the jack overloaded which is causing the excessive amperage draw? What jack do you have? Can you see an amperage rating on it anywhere which would give you an idea what it should be drawing?
It's possible the jack screw/gear is damaged too which would cause the motor to have to work too hard for standard use which might overdraw it's power circuit.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Q&A: Looking for Replacement Hydraulic Gear Pump 196895
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: Brake Controller Installation: Starting from Scratch
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Activate 12V Trailer Power Circuit on 2017 Ford F-350 Super Duty
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today




Lee B.
7/29/2019
Jameson thanks for the feedback I am going to replace the unit with a manual tongue jack I appreciate the help