Distance from Weld Stop to Center of Shaft on Lippert Landing Gear Leg # LC179013
Published 07/25/2019
Question:
I was wondering what the distance is from the top of the top weld on bracket to the center of the shaft, I am looking to replace some 31inch atwood landing gear and want to make sure things will line up Thank you
asked by: Jason M
1
Helpful Expert Reply:
The distance from the top of the upper weld of the Lippert leg part # LC179013 to the center of the shaft measures 6.4 inches.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Continue Researching
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Video: Lippert Components Trailer Jack LC179013 Review
- Search Results: 5th wheel front landing gear
- Search Results: 5th wheel landing gear
- Q&A: Replacement Lead and Follow Legs for 5th Wheel Landing Gear on Jayco Trailer
- Q&A: Recommended Lead Leg Landing Gear for Atwood Replacement
- Q&A: What Replacement Landing Leg do I Need for My 2000 Jayco Eagle Fifth Wheel Camper?
- Q&A: Troubleshooting Lippert Landing Gear Lead Leg Not Fully Retracting
- Q&A: Landing Gear Replacement Leg for 2007 Alpenlite Defender
- Q&A: How do Lippert Landing Gear Legs Attach to a Trailer Frame
- Q&A: Landing Gear for a 2009 Heartland Bighorn 5th Wheel Trailer
- Article: Holiday 2025 | Best Gifts for RVing
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Best Landing Gear
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Carrying Bikes While Towing a 5th Wheel Camper Trailer
- Article: RV Roof Types: What Type of Roof Does My RV Have?