Does Return Vent Need to Install on Sewer Tank When Installing Cyclone RV Plumbing Vent
Updated 07/10/2019 | Published 07/09/2019
Question:
I intend to use this product as part of my sewer venting system in my camper renovation. Do I need to add something like a check valve or on-line valve for air to enter into the black tank in order for the cyclone to be able to pull air out ?
asked by: Drew S
Expert Reply:
You do not need to add any additional valves or holes in your sewer tanks when installing this Cyclone RV Plumbing Vent # CAM40597. The fin that runs through the horizontal opening allows air to be pulled out while allowing air to return back to the tank enough that it's still effective. The amount of air needed to move out of the tank for this to be effective is not a high enough volume that you'd need a return vent as well.
Product Page this Question was Asked From
Camco Cyclone RV Plumbing Vent - 1-1/2" Pipe - Black
- RV Vents and Fans
- Vent
- Plumbing Vent
- Roof Vent
- No Fan
- Plastic
- Black
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Shop: RV Propane Gas Detector - 12 Volt - 2 Wire - Black
- Video: Feature Breakdown: Camco Cyclone RV Plumbing Vent
- Shop: Camco Cyclone RV Plumbing Vent - 1-1/2" Pipe - Black
- Q&A: Could the Cyclone RV Plumbing Vent # CAM40597 be Used to Ventilate a Camper Van
- Q&A: How Does the Cyclone RV Plumbing Vent Install
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Article: Trailer Wiring Diagrams
- Search Results: trailer tires and wheels
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Shop: Trailer Wiring
- Article: Trailer Lighting Requirements
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Search Results: trailer wiring
- Q&A: Recommended Replacement for Atwood RV Propane Gas Detector 31013
- Article: How to Accurately Measure Trailer Leaf Springs
- Shop: Suspension Enhancement
- Shop: Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Search Results: trailer jack
- Article: Double-Eye Trailer Suspension System Review
- Shop: Base Plate for Tow Bar
- Shop: Brake Controller
- Video: Breaking Down the RV Propane Gas Detector
- Q&A: Will a Furrion Chill Cube RV Air Conditioner Fit the Some Cutout as a Dometic AC?
- Search Results: trailer leaf springs
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
on RV Vents and Fans
