How Does the Cyclone RV Plumbing Vent Install

Question

Question:

Does it get attached with the screws to the pipe or roof

asked by: Charles H

0

Expert Reply:

The main piece that attaches to the pipe is what gets screwed onto the pipe using the 3 included self-tapping screws. So you would insert the Cyclone RV Plumbing Vent # CAM40597 into the existing pipe on the roof and then use the screws through it and the roof pipe to hold it in place. I have linked a video review of this vent for you.

expert reply by: Michael H

0

Answer 1

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 2

You do not need to add any additional valves or holes in your sewer tanks when installing this Cyclone RV Plumbing Vent #CAM40597. The fin that runs through the horizontal opening allows air to be pulled out while allowing air to return back to the…

view full answer...

Answer 3

Moving air is what the Cyclone RV Plumbing Vent #CAM40597 is designed to do. If you wanted to use it as an exhaust vent for a camper van it would work just fine for that. These would work great to pull air out of your camper as you are moving or…

view full answer...

Answer 4

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 7

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 8

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 9

I sure can BJ. To add a keyless entry lock to your 2025 Airstream, I recommend the Bauer NE RV Entry Door Lock for Trailers item #BA33UR for a left handed lock or item #BA53UR for a right handed lock. These locks have Bluetooth capability and a PIN…

view full answer...

Answer 10

If what you have now Chad is pretty flat at 26 inches then the best replacement size would be 25-1/4 inches like you mentioned. Since you wanted to increase the capacity you would want the part #e57SR which is for 4k trailer axles.

view full answer...

Answer 11

Ron, you’ll be fine with two people. Each Thomas Payne Rest Easy Trifold Loveseat - whether it’s the Dellmead #TP49KR, Driftwood #TP69KR, or McCoy #TP79KR - weighs around 153 pounds, and it ships in two manageable sections (the base and the back), so…

view full answer...

Answer 12

Hey Scott! In order to get you the correct grease cap I am going to need you to take a measurement off of your hubs pilot hole or one of your other center caps. The Grease Cap item #RG04-040 you were looking at has an outer diameter of 1.99".…

view full answer...

How Does the Cyclone RV Plumbing Vent Install

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching