Will Brake Controller Install Harness # 3024-P Plug into Back of Prodigy P3 Brake Controller

Question

Question:

Does this adapter plug direct into the back of the P3 Prodigy controller. The plug looks similar, but Im making sure.

asked by: Roy O

0

Expert Reply:

Yes, the black connector on the Tekonsha brake controller install harness part # 3024-P that you referenced will plug right into the back of a Prodigy P3 brake controller part # 90195.

expert reply by: Jameson C

0

Answer 1

The Optronics LED Clearance or Side Marker Trailer Light is available in Red #MCL0030RBB and Amber #MCL0030ABB. These are the closest replacements to the Glo Brite 122r/122y lights you have. The lights only have one LED diode versus the 3 in your…

view full answer...

Answer 2

What you sent in a picture of is the #LC123356 which the 18 tooth gear part #LC122739 you mentioned is designed to work with.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Will Brake Controller Install Harness # 3024-P Plug into Back of Prodigy P3 Brake Controller

Continue Researching