How Long Is the Pollak Metal 7-Pole, RV-Style Trailer Connector Part # PK12702
Updated 06/10/2019 | Published 06/09/2019
Question:
How long is this part? My standard Reese 7-pin connector interferes with my weight stabilizer bar, which is plugged into the power module on my trailers frame. If I had a shorter 7-pin I could use my stabiliser bars again. Thanks!
asked by: Stewart G
Helpful Expert Reply:
The Pollak Metal 7-Pole, RV-Style Trailer Connector part # PK12702 is 2-3/4" long from the face to the rubber boot on the back. This is currently the shortest trailer connector we offer so if you still do not have enough room you might want to consider moving the frame bracket for the weight distribution system just a bit. The frame brackets usually have a range that they can be installed in rather than a set point anyhow.
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: How to Test If Redarc Liberty Brake Controller Is Working
- Q&A: Can a Breakaway System and Brake Controller be Installed at Same Time on 2002 Dodge Grand Caravan
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: Does the Bigfoot Hydraulic Jack Come with the Switches or Remote?
- Q&A: Why Does the etrailer Trailer Hitch part # e72AR Have a Higher Towing Capacity than the Vehicle?
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Article: How to Fix a Bad Trailer Ground
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch