One Leg On Lippert Ground Control Not Touching After Screen Shows Successful

Updated 06/03/2019 | Published 05/31/2019

Question:

One of my jacks is not quite touching, although the autolevel declared success.

asked by: Glen H

Expert Reply:

It sounds like you just need to reset the zero point. In order to do this you will need to follow the steps I have attached for you below and in the photo. If this does not fix your issue then please just let me know and I will see if we have any other actions for you to preform.

1. Manually run the jacks to level the unit. This is best achieved by placing a level in the center of the unit and leveling it both front to back and then side to side.
2. Once the unit is level, turn off the touch pad.
3. With the touch pad off, press and release the “front” button 10 times and then press and release the “rear” button 10 times.
4. The touch pad will flash and beep and the display will read “zero point calibration enter to set, power to exit” (Fig. 5).
5. To set the current position as the zero point, press the “enter” button.
6. LCD display will read “zero point stability check” (Fig. 6).
7. LCD display will read “zero point set successfully” once process is complete (Fig. 7).
8. The system will set this point as its level state and the touch pad will turn off.

expert reply by: Conner L