What are the Dimensions of the Mounting Holes on the Brophy Trailer D-Ring Tie Down
Question:
One of the answers in the RR5K kit says the holes are 3 1/2 on center. In the RR5 without the kit the drawing shows 3 1/4 one way and 3 the other. Im trying to fit these as replacements for existing old recessed D rings and exact dimensions are very important. So...whats the scoop? Am I reading something wrong?
asked by: Bill P
0
Expert Reply:
I went out into our warehouse and pulled a Trailer D-Ring Tie Down # RR05 to measure the mounting holes on center and found them to be 3 inches by 3-1/4 inches like the picture suggests.
I attached a video that shows these measurements for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 4-7/8" Wide - Recessed Mount - 1,600 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1600 lbs
- D-Ring
- Recessed Mount
- Brophy
more information >
Continue Researching
- Q&A: Recommended Backing Plate for the Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: Mounting Hole Spacing For Square D-Ring Tie-Down Anchor ABS69FR
- Q&A: What Size Hole Saw Is Needed To Install Square D-Ring Tie-Down Anchor ABS69FR To Floor?
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: How Long are Bolts for Recessed Trailer D-Ring part # RR5K
- Q&A: Storage Cover for 24-Foot Haulmark Car Hauler Enclosed Trailer
- Q&A: Does Brophy Swiveling D-Ring Anchors Come with Hex or Carriage Bolts
- Q&A: Longer Ball Mount Recommendation for Adding Distance Between Hitch Ball and Bumper
- Article: How Much Weight Can I Put on My Trailer Hitch?
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Measure Your Trailer Wheel Bolt Pattern