Do I Need A Driver or Press When Installing 50MM Nev-R-Lube Bearing

Updated 05/28/2019 | Published 05/23/2019

Question:

I have a 8000 lb dexter axle with Kodak disk brake hubs on my rv that have 50 mm never lube bearings. Do I need a press to replace the bearings? Where do I find tool to install bearings? Thank you

asked by: Butch

Expert Reply:

No, I contacted the tech at Dexter and you do not have to press the bearing in place with a driver when installing 50MM Nev-R-Lube bearings for 8,000-lb Dexter Axles part # 31-71-3 because there are not any races or seals to drive into place.

When installing you can use a dowel to gently tap the bearing into place to prevent damage. A lot of our customers like the Nev-R-Lube bearings because you do not have to worry about seals, races, or repacking the bearings because all of the components are combined into one part.

expert reply by: Heather A