How To Use the RoadMaster Single Hook Safety Cables With Large Clevis On Jeep Bumper
Updated 04/30/2019 | Published 04/29/2019
Products Featured in This Question
Question:
I recently purchased this item for my setup. The hooks do not fit over a 3/4 Clevis on my jeep. Im looking for ideas how to make this work? The hook opening is about 3mm to small. Thank you.
asked by: Kelly J
0
Expert Reply:
The best option I have for you to use the RoadMaster 76" Single Hook, Straight Safety Cables part # RM-645-76 with the larger clevis on your Jeep would be to install a larger hook on the safety cables. For this, we have 1/2" options like part # TCSLIP-G70-13-L as well as 5/8" options like part # C81920.
expert reply by:
Conner L
0
Product Page this Question was Asked From
RoadMaster 76" Single Hook, Straight Safety Cables - 8,000 lbs
- Safety Cables
- Straight Cables
- 76 Inch Long
- 8000 lbs GTW
- Snap Hooks
- Coated Cables
- Roadmaster
more information >
Continue Researching
- Q&A: Flat Tow Set Up For a 2026 Jeep Wrangler Rubicon
- Q&A: Base Plates, Safety Cables, Lighting, and Braking System to Flat To a 2010 Nissan Frontier
- Q&A: How To Determine If My RV Has a Charge Line for Flat Towing Present
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How Level Should a Tow Bar Be When Flat Towing
- Q&A: Replacement Wear Plate 14711 For Demco Autoslide 18k & 21k Fifth Wheel Hitches
- Q&A: Recommended Keyed Alike Locking Hitch Pins For 2" and 2-1/2" Receiver
- Q&A: Best Battery Charge Line Kit for Flat Towing
- Q&A: How to Connect an etrailer Baseplate to a Roadmaster Tow Bar
- Article: How to Choose a High-Low Adapter
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Anti-Rattle Devices