Ball Mount With 2 Inch Rise for 2 Inch Trailer Hitch and Warranty of 4-Way Bracket

Updated 04/25/2019 | Published 04/24/2019

Products Featured in This Question

Curt Class III Drawbar - 2" Rise - 4" Drop - 13" Long - 7,500 lbs

(2327)

$38.94

2" Hitch Ball - 1" Diameter x 2-1/4" Long Shank - Chrome - 12,000 lbs

(4012)

$23.09

Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-3/16" Span

(2977)

$5.03

1-7/8" Hitch Ball - 1" Diameter x 3" Long Shank - Chrome - 3,500 lbs

(4010)

$17.21

etrailer Trailer Hitch Receiver Lock for 2" Hitches - Flush - 2-5/8" Span - Chrome

(3785)

$26.66

Question:

The top of my hitch tube is at 14 inch and the bottom of my trailer tongue is at 16. I tried a ball mount with a 4 inch rise and the trailer does not sit very level at all. it is a single PWC trailer. Do you have a ball mount for a 2 inch receiver that has a 2 inch rise? Also another question: 2 years ago when I purchased and had installed my hitch from eTrailer I had you install Mounting Bracket 4-Pole Flat Item # 18144. The hitch is fine, but the wiring bracket is rusting badly. Is there a corrosion warranty on this item? Thank you,

asked by: Jeff K

Expert Reply:

You are absolutely right that you need a ball mount with a 2 inch rise since your coupler is 2 inches above the top of your hitch receiver. The Curt Class III Drawbar # C45270 is a great option that fits in a 2" hitch and you can use either Pin and Clip # C21500 or Trailer Hitch Receiver Lock # e98880 to secure it to your hitch. For a hitch ball, depending on your trailer's coupler you will need 1-7/8" Hitch Ball # C40017 or 2" Hitch Ball # 40038.

In regards to Mounting Bracket # 18144 it comes with a 1-year warranty so if yours is in need of replacing you would need to purchase a new one.