How to Determine Correct Grease Seal for Homemade Trailer  

The best way to select a new hub is to match it based on the bearing set used in the original part. New hubs must use the same bearings as your old ones in order for them to fit on your spindles, so if you can find the part numbers from your inner…

It sounds like you need a 10-60 seal, part #RG06-020. It has a 1.5 inch innder diameter and 1.987 outer diameter. It also fits a BTR spindle which bearing #L44649 is both the inner and outer for. If you need the complete bearing kit use part…

The grease seal that is commonly used with the hubs that have inner/outer bearings of L44649 is the #RG06-020. These seals have an inner diameter of 1.50 inches and an outer diameter of 1.987 inches. You can measure yours to determine if this would…

If you are looking for a grease cap PLUG with the TRP stamped on it chances are the Grease Cap Plug for E-Z Lube Grease Caps #RG04-010 would work for you, but to be certain you will want to measure the diameter of the grease cap hole. If it is 1.18…

The seal set you need is the part #RG06-020 which is a confirmed fit as a replacement for what you have.

For marine applications the best type of grease seal is a "double lip" seal which has a rubber spring that wraps around the seal to help hold it tight to the spindle so that it doesn't leak water. So for a double lip seal that fits the…

I went out to the warehouse and found that the TruRyde Grease Seals #RG06-020 that you referenced are 1/4" thick. If the ID and OD are correct for your application then this is the correct set of grease seals for you as those are the determining…

To replace the 15192TC double lipped grease seal in your hub, I recommend grease seal pair #RG06-020 which has an inside diameter of 1.5 and outside diameter of 1.987 which is confirmed as a replacement for the 15192TC. They are the closest seals we…

Thank you for the information! It sounds like you have a BTR spindle which means you need a grease seal that has a 1.500" ID and 1.987" OD. For this we have part #10-9 for a single seal or part #RG06-020 for a pair of seals.

The inner and outer bearings should have a part number stamped on them. The grease seal typically has a number stamped on the rubber, as well. If you cannot find the number on the seal, the inner diameter of the seal can be used to find a…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…