Are Washers Always Needed Between Spindle Nut and Outer Bearing
Published 04/11/2019
Products Featured in This Question
Question:
no washer needed on the outer bearing before the nut-between the nut and the outer bearing?
asked by: Ed H
1
Helpful Expert Reply:
Spindle washers aren't always used. We actually sell complete axles with hubs like the # 20440I-ST-72 which does not come with washers. Typically if a washer is needed it will be on a higher capacity hub/axle.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- 2500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Does Furrion Chill Cube Require Freeze Sensor Installation
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: Is There Fas-Top Topper that Fits 2024 Ford E-350 Long Bed
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Replacement Bearing and Seal Kit with Grease for a Malone MicroSport Trailer
- Q&A: Where are Timken Bearings Made
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Bearing Kit and Bearing Buddy that Fits Malone MicroSport Trailer
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Double-Eye Trailer Suspension System Review
- Article: Is It Illegal to Leave My Hitch on My Truck?