Grease Recommendation for Venture Landing Gear Leg with Zerk Fitting
Updated 04/09/2019 | Published 04/08/2019
Products Featured in This Question
Question:
It Has two Grease zerts on each side but I’m sure there is a procedure on how to re-track them properly and grease them Please help
asked by: Steve B
Helpful Expert Reply:
We have spoke with our contacts at Lippert/Venture about greasing their landing gear legs that have zerk fittings and they recommended a white lithium grease like # L11354 for the zerk fitting for the gears and a silicone based lubricant on the exterior of the legs.
There isn't a set schedule for how often to grease the legs. It's basically an as-needed basis.
Product Page this Question was Asked From
Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: The Low-Down on the Replacement Motor for Stromberg Carlson Electric Landing Gear
- Video: A Closer Look at the LubriMatic White Lithium Grease
- Q&A: Replacement Part Availability for Venture VMC900L Landing Gear
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Landing Leg Replacement for 2009 Heartland 3055 RL
- Q&A: Replacement Jack Legs for Venture VMC900R Landing Gear
- Q&A: What Water Pump Can I Use in a 2013 Heartland Cyclone 5th Wheel
- Q&A: Replacement for a Triple Vision Backup Camera and Monitor
- Q&A: Recommended Replacement Lead Leg for Bent Leg on Jayco 5th Wheel Trailer
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Hitch Receiver Sizes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing