Can LED Trailer Tail Lights be Used With Original Wiring on Older Boat Trailer
Updated 04/08/2019 | Published 04/05/2019
Question:
Boat Trailer - My boat trailer is dated 1982 with original wiring. Can I keep the original wiring and use the V944 LED lights?
asked by: Patrick J
0
Expert Reply:
You can use the Peterson Light Kit # V944 on your boat trailer from 1982 with its original wiring. Just make sure that the wires are in good shape and not stripped or otherwise damaged/exposed and these LEDs will work.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Peterson Light Kit for Trailers Under 80" Wide - 20' Harness - Driver and Passenger
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Marker
- Square
- Surface Mount
- Incandescent Light
- 4-3/4L x 4-1/2W Inch
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Will The Peterson M540 Light Kit Fit A Bracket With 2-1/4" of Head Room?
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Trailer Wiring for 5x10 Trailer with 4-Way Trailer Connector
- Q&A: Complete Replacement Wiring Setup for Lights and Brakes on a Trailer
- Article: Boat Trailer Guides: Which are the Best?
- Q&A: What are the Proper Components Needed to Install the Leaf springs On a Trailer
- Q&A: How is the 30-20 Hanger Designed For Mounting On Its Side and Not Facing Down
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Q&A: How to Connect Gooseneck Safety Chains to Coupler With D-Rings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs