Ball Mount Recommendation for Use with Curt Hitch # C11487

Updated 04/02/2019 | Published 04/01/2019

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(62)

$216.85

1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs

(348)

$35.24

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(348)

$37.43

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2291)

$49.46

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(19)

$45.61

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2958)

$3.57

Question:

draw bars

asked by: Shanon M

Expert Reply:

Sounds like you might be looking for the correct draw bar, or ball mount, for use with the Curt hitch part # C11487 that you referenced. For that Curt recommends the part # C45521. For a hitch ball you'd then want the part # A-82 for a 2 inch ball or part # A-80 for a 1-7/8 inch ball. For a pin and clip part # F-4.

If you needed trailer wiring you'd want the Curt kit part # C56030 which is an easy to install kit that does not require splicing.