Should 20-Amp or 30-Amp Circuit Breaker be Used When Installing ETBC7 Wiring and Prodigy P2
Updated 03/27/2019 | Published 03/25/2019
Products Featured in This Question
Question:
Instructions for # ETBC7 state to use the 20- or 30-amp circuit breaker based on the manufactures requirements but I cannot locate that for my tekonsha prodigy p2.
asked by: Cullen W
Helpful Expert Reply:
When installing the Universal Wiring Kit # ETBC7 so you can use the Prodigy P2 # 90885 you will want to use the 20-Amp circuit breaker if you your normal trailer has 2 to 4 brakes or the 30-Amp circuit breaker if your normal trailer has 6 to 8 brakes.
If your tow vehicle is the 2015 Subaru Forester that you put in for your vehicle info then you should only need the 20-Amp breaker. A trailer with 6 to 8 brake assemblies (3 to 4 axles) would be way too heavy for your vehicle.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Splice-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LED Display
- Single Trailer Only
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: DeeMaxx Disc Brake Kit w/ Actuator for Tandem Axle Trailers - 13" Rotor - 8 on 6-1/2 - 7K
- Shop: Dexter Trailer Idler Hub Assembly for 5,200-lb to 7,000-lb E-Z Lube Axles - 8 on 6-1/2
- Shop: DeeMaxx Trailer Idler Hub for 7,000-lb Axles - 8 on 6-1/2 - Galvanized
- Q&A: Idler Hubs and DeeMax Slip On Disc Brake Kit for 2019 Big Country 3360ss
- Shop: Dexter Trailer Idler Hub Assembly for 5,200-lb to 7,000-lb Axles - 8 on 6-1/2 - Galvanized
- Search Results: idler hub
- Search Results: accessories and parts
- Shop: Easy Grease Trailer Idler Hub Assembly for 7,000-lb E-Z Lube Axles - 8 on 6-1/2 - Pre-Greased
- Shop: Timken Replacement Trailer Wheel Bearing - 25580
- Q&A: Correct HydraStar Disc Brake Kit for 50' Kaufman Car Hauler Trailer
- Q&A: Electric Over Hydualic Disc Brake Setup for 2020 Grand Design Momentum 376THS
- Q&A: Parts Needed to Install Disc Brakes on a Trailer with Drum Brakes
- Q&A: Upgrading Hubs From 6 Bolt to 8 Bolt for 5,200 lb Axles
- Q&A: Replacement Grease Seal for National 413470 Seal
- Q&A: Determining Which HydraStar Disc Brake Kit Fits 2017 Grand Design Momentum W/ Triple Axles
- Video: Feature Review DeeMaxx Disc Brake Kit w/ Actuator for Tandem Axle Trailers
- Video: Detailed Breakdown of the DeeMaxx Trailer Idler Hub for 7,000-lb Axles
- Video: Dexter Axle Trailer Hubs and Drums - Hub - 8-231-9UC1-EZ Review
- Video: 2020 Keystone Montana Fifth Wheel DeeMaxx Disc Brake Kit: Complete Installation
- Search Results: kodiak trailer hubs and drums
- Search Results: wheel studs
- Search Results: 1/2 wheel stud
- Search Results: trailer hubs
- Search Results: 1/2 inch studs
- Shop: Dexter Trailer Idler Hub Assembly - 5,200-lb, 6,000-lb and 7,000-lb Axles - 12" - 8 on 6-1/2