How To Prevent Pre-Collision Warning Error When Installing Brake Controller 2017 Toyota Highlander

Updated 03/20/2019 | Published 03/19/2019

Products Featured in This Question

Tekonsha Primus IQ Trailer Brake Controller - Up to 3 Axles - Proportional

(2159)

$90.04

Roadmaster Single Park Light Diode

(120)

$22.21

Question:

I got the Tekonsha Primus IQ brake controller for my 2017 Toyota Highlander. When I apply just the trailer brake with the slide switch, I get an error message on the Toyota Pre-Collision System Malfunction.

asked by: SPILLAR C

Expert Reply:

I spoke with my contact at Tekonsha who knew exactly what you were talking about.

He said that the best solution for installing a brake controller like the Primus IQ # TK90160 in your 2017 Toyota Highlander is to install a diode on the red wire of the wiring harness for the Primus IQ. This is the wire that connects to the cold side of the stop light switch.

To prevent the 12V from backfeeding into your Pre-Collision System he recommended using a diode rated for 1 amp or are part # RM-690 with the "IN" side pointed towards the vehicle.

expert reply by: Jameson C