Replacement Landing Gear Motor Recommendation for Motor with 7,140 RPM
Published 03/05/2019 >
Products Featured in This Question
Question:
Have a 2010 montana 333db. Front landing gear seems to struggle...actually its not lifting at all. It seems that the motor is dead or super close to dead. Even retracting the gear is slow. I have this motor model 1-065-0410112-01. It says its a 7140rpm on the label. The grounds all seem clean and clear. Will verify before ordering..... can you tell me what the best way to test this motor is? Should i jumper it to the battery? If i need a new motor. Whats the best replacment for it?
asked by: Terry M
Expert Reply:
The correct replacement motor you'd need is the part # LC141893 if you do determine that the motor is at fault. If the battery on the trailer is in good working order and all of the wiring is clean and tight it would have to be the motor. You could try running a jumper wire from your vehicle battery to further test this if needed.
Continue Researching
- Search Results: atwood~gear
- Shop: Replacement Motor with Clutch for Lippert Ground Control 2.0 Electric Leveling System
- Shop: Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Shop: Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies
- Q&A: Landing Gear Replacement for Trailer with Atwood Jacks
- Q&A: Correct Replacement for Atwood 71119 Landing Gear Motor
- Q&A: Troubleshooting Lippert Landing Gear Motor 1-065-041012-01 Blowing Fuse Under Load
- Q&A: Replacement Electric Motor For Landing Gear 1-065-041012-01
- Q&A: Replacement Motor Solution for Atwood MPD 71119 Landing Gear
- Q&A: Replacement Motor for Atwood Landing Gear 75271
- Q&A: Replacement Heavy Duty Motor For Landing Gear On 2010 Keystone Raptor Toy Hauler
- Shop: Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Shop: Replacement Socket for Stromberg Carlson Leveling Scissor Jack Set with 30" Lift
- Shop: Replacement Manual Jack Handle for etrailer or RAM Electric A-Frame Jack
- Shop: Replacement Manual Crank Handle for etrailer Scissor Stabilizer Jacks
