Cleaning Pins of Lippert Ground Control Leveling System Remote

Published 02/20/2019

Question:

Did as one suggested: Had no display on pad but it lights up. Unplugged for 15 mins. Re-connected and worked OK. Then quit again. Same procedure worked again for a little while but now it comes on and then just fades away. Also suggested to clean connection. What do you use?

asked by: Jake F

Helpful Expert Reply:

I attached a picture of the pins that are on the back of the display of the Replacement Auto Level Control Panel for the # LC675817. I'd take some sandpaper and rough up the pins till they are down to bare metal (assuming corrosion is there) and the connection should be good. Also try checking the opposite connection where this plugs in for corrosion there. An easy way to clean out a female electric connector is pour Coca Cola on a toothbrush and brush the pins as well as you can.

expert reply by: Jameson C