Where is the Brake Light Switch Wire on a 2013 Toyota Highlander

Updated 01/02/2019 | Published 12/30/2018

Question:

Im 95 complete on the installation of the ETBC7 and Brake Controller. Im at the step where I have to connect the RED wire on the brake controller to the brake wire under the dash. I have a 2013 Toyota Highlander SE. Ive followed the video instructions you have up to this point. I cant find the wire under the dash for tapping into. Can you HELP???

asked by: Lee

Expert Reply:

I am not sure which video you are referring to but if you take a look at the 10:45 mark in the attached install video on a 2013 Toyota Highlander, you will see exactly where the bundle of wires are that you will need to tap into for the brake light circuit. The wires are most likely taped up and hidden near the emergency brake pedal so it will take a bit of digging to find them. Once you find the bundle it should be the blue/gray wire that you need to splice into but you will want to test this with a circuit tester first. I hope this help!

expert reply by: Conner L