Lippert SolidStep Compatibility with Threshold and Door on 2010 Keystone Montana

Published 11/09/2018

Question:

I think you misunderstood metheres already one step made into the trailer floor I want to know when I raise as step up is it going to be in the way can you tell me how wide The Bean Is on your step railI only have eight and a half inches from where you open the door and thats step inside if I knew how big your frame was is it 8 and 1/2 in at 9 in at 10 in the I-beam thats what I need to know

asked by: Butch D

Expert Reply:

We do not carry the Morryde steps so I can't speak to their fit, but we do carry the similar Lippert SolidStep Manual Fold-Down Steps like # LC791575. These have a lip that will go over the threshold you are referencing and will allow the door to close in most cases. I have had one customer with an almost flush threshold that required removing some of the flooring material to allow the fit and door to close, so I do know that customization was required on one trailer but most allow this step to fit and not have any issues with the door.

I've linked the page to all your options because the steps are dependent on threshold height and door frame width. This information is clearly outlined on each product page to assure you get the correct fit. Let me know if you have further questions.

expert reply by: Jason S

click to enlarge

Butch

11/9/2018

Jason S.

11/9/2018

I went out to the warehouse to measure the SolidStep # LC791575 for you and it is 6-7/8 inches wide at the normal I-beam portion and at its widest with the bracket at the top 9-5/8 inches. I've attached a photo to assist.