Will My Brakes Fit the Dexter Trailer Axle Beam with 4" Drop Part # 7685269
Published 11/02/2018
Products Featured in This Question
Question:
My existing Axle has brakes. Will they bolt on to this axle? Item # 7685269
asked by: Ervin
Expert Reply:
The Dexter Trailer Axle Beam with 4" Drop part # 7685269 has four bolt brake mounting flanges already welded on. Therefore, if the brakes you have now have this same four bolt brake mounting flange then they will transfer over. The four bolt brake mounting flange is common on 10" x 2-1/4" braking assemblies like part # AKEBRK-35-SA which are commonly found on 3,500 lb axles. If you have a 3,500 lb axle now then they will most likely work for you but you can check by counting the brake mounting flange bolts.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 95" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 80 Inch Spring Center
- 95 Inch Hub Face
- Drop - 4 Inch
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Is 76" Spring-Center Measurement Abnormal for 95" Wide Trailer Axle
- Q&A: Recommended Replacement Weld on Trailer Jack for a Phoenix Boat
- Q&A: Recommended Leaf Springs, U-Bolts, and Suspension Bolts for a 2,000 lbs 1-3/4" Diameter Axle
- Q&A: Replacement for a Marine Master Boat Trailer Axle
- Q&A: Adding Lift to 3,500 lb Trailer Axle
- Q&A: Replacement Hub/Drum and Brake Assemblies for Dexter 12k Axle
- Q&A: Replacement Axle For a Stealth 7.5X12 Cargo Trailer 3,500-lb 93.5" Hub Face 77.5" Spring Center
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Double-Eye Trailer Suspension System Review
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Maintenance Schedule
- Article: No Missteps Here: Best Camper and RV Steps (2022)