Reseting Zero Point of Lippert Ground Control Leveling System

Published 09/25/2018

Question:

can you email me the directions or manual how to reset the zero point for my 2013 jayco eagle premier 40 footer with four slides please. My system will not auot level for some odd reason. Works from control module front or back or sides but not auto level.

asked by: David A

Expert Reply:

Zero Point Calibration

The “Zero Point” is the programmed point that the trailer will return
to each time the Auto Level feature is used.

Note: Prior to starting this procedure, double check all connections
on the controller, jacks, and touch pad.

1. In manual mode, run the jacks to level the trailer. This is best
achieved by placing a level in the center of the trailer and leveling
it both front to back and then side to side. (See “Basic Jack
Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO
POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER”
button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is
complete.
8. The system will set this point as its level state and the touch pad
will turn off.