Mounting Hole Pattern for Fulton Trailer Jack FXP10
Updated 09/10/2018 | Published 09/07/2018
Question:
I’m trying to replace the trailer jack and I know a question was asked, but the answer given was telling us what trailer tube thickness the jack would work with. I need to know what the center to center bolt pattern is on the jack plate to see if it will bolt up. My bolts center to center are 3” x 5.5”
asked by: John
0
Expert Reply:
On the Fulton Jack # FXP10 the center to center mounting hole spacing can be seen in the photo I linked for you. This 1200-lb-rated jack is intended for installation on 3 x 5-inch trailer frames.
expert reply by:
Adam R
0
click to enlarge
Continue Researching
- Search Results: fulton xlt jack
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Q&A: Recommended Replacement for Fulton Magnum Series Trailer Jack
- Q&A: Weld On Bracket Recommendation for the Fulton XLT Swivel Trailer Jack # F141133
- Q&A: Is There a Fulton XLT Jack Rated for 1,500LBS Which With Fit a 2-1/2" Diameter Snap Ring Bracket?
- Q&A: Can a New Fulton Bolt-Thru Jack Be Used in Place of an Older Jack with a Weld-On Bracket
- Q&A: Mounting Bolt Pattern on Fulton XLT Trailer Jack # 141401
- Shop: etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 11" Lift - Zinc - 1.5K