Converting Yakima HoldUp Bike Rack to Work in 1-1/4 Trailer Hitch
Published 08/08/2018
Products Featured in This Question
Question:
Hi, I have a Yakima Holdup for 2 bikes that currently has a 2 inch receiver. I have purchase a new vehicle but the receiver is only 1.25 inch. Is there a replacement 1.25inch shank available, or do I need to purchase the whole spine/shank assembly? Many thanks
asked by: Kathy F
0
Expert Reply:
You can convert your Yakima HoldUp # Y02443 for 2" hitches to work with a 1-1/4" hitch with just the tongue assembly, which is Replacement 1-1/4" Tongue for Yakima HoldUp Bike Racks # 8880581. You will not need any new hardware to install this assembly on your current HoldUp.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Replacement Spine for Yakima HoldUp 2 Bike Rack for 1-1/4" Hitches - Black
- Accessories and Parts
- Hitch Bike Racks
- Shanks and Adapters
- Main Assembly
- HoldUp
- Yakima
more information >
Continue Researching
- Q&A: Weight Capacity of Step on Benton LittleShift Bike Rack
- Q&A: Will Replacement 2" Hitch Shank for Yakima HoldUp Fit Older HoldUp Bike Racks
- Q&A: Replacement Bike Tray Assembly for Yakima HoldUp Bike Racks
- Q&A: Troubleshooting Stuck Hitch Pin in Yakima Bike Rack
- Q&A: Replacement Parts For The Yakima HoldUp EVO Bike Rack
- Q&A: Replacement Spine and Hardware for Yakima HoldUp Bike Carrier
- Q&A: Replacement Mounting Bolt Kit for Yakima HoldUp Plus 2 Bike Carrier Y02446
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Trailer Maintenance Schedule