Mounting Hole Size for CE Smith Trailer License Plate Bracket CE26053A
Updated 08/03/2018 | Published 08/02/2018
Question:
I am curious the whole size to attach to the back of the light? I have some military lights, like hummer. I think I need 7/16 bolt size. I appreciate any help!!!!
asked by: Brad
0
Expert Reply:
The holes in bracket # CE26053A are elongated and measure 7/16 inches side to side and 1/4 inch top to bottom. You would need to bore out the holes a little to use 7/16 inch diameter hardware.
expert reply by:
Michael H
0
Product Page this Question was Asked From
CE Smith Trailer License Plate Bracket - Tail Light Mount - Aluminum Tread Plate
- Accessories and Parts
- License Plates and Frames
- Mounting Hardware
- Brackets
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Proper Torque for Shackle Bolt for 1-3/4" Wide Double Eye Springs 007-003-01
- Q&A: Parts Needed to Add Self-Adjusting Electric Brakes And Hub & Drum on 3,500 lb Axle
- Q&A: Replacement Bearings, Hubs, and Brake Assemblies for a Apex Nano w/ 3,500 lbs Axles
- Q&A: Replacement License Plate Bracket for Triton Jet Ski Trailer
- Q&A: Installation Instructions For The Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch
- Article: Most Popular Wheel Bearings
- Q&A: Metal License Plate Holder and Bracket for a 2012 Karavan Boat Trailer
- Q&A: Recommended License Plate Mount For Fender of Car Hauler Trailer
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Article: Determining Trailer Tongue Weight
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers