How Would a Custer Back-Up Alarm Install on a Reverse Light Circuit of a Vehicle with a 7-Way
Published 09/26/2011
Question:
Where can I get the installation instructions for BKUP-97? I see 2 contacts for the unit. is one is for goiund? and can I hook the other to the purpule wire from my 7 pin trailer harness? Thanks
asked by: Paul
Expert Reply:
What you could do to install this Surface Mount Back-up Alarm # BK97DB is install it inline with the purple wire of your 7-way. You would cut the purple wire and then attach one end of the wire to one of the contact studs and then attach the other wire to the other stud, and then when there is voltage on this circuit the voltage will run through the # BK97DB activating the alarm and then go to the 7-way.
I attached an FAQ article on trailer wiring for you to check out also.
Product Page this Question was Asked From
Surface Mount Back-up Alarm - 97 DB
- Back Up Alarm
- Low Volume
- 97 Decibels
- Surface Mount
- Custer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability Of Trailer Hitch For 2025 BMW i5 M60
- Q&A: Compatibility of the Curt Wiring Harness # 56229 with Hopkins Endurance Connector
- Q&A: Back Up Alarm that Fits 2008 GMC Canyon
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: What Is The Recommended Lug Nut Torque On 7,000lb Axles?
- Q&A: Bow Roller Recommendation for a Trailer with a 3-5/8 Inch Wide Bracket
- Q&A: When Would a Trailer Break Away Kit Be Required By Law
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Testing Brake Controls
- Article: Testing Breakaway Systems
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide