Replacement Landing Gear Foot Pad for Fifth Wheel Trailer

Question

Question:

How can I be sure your Lippert Components 5th Wheel RV Landing Gear Foot Pad - 9inch Round will fit my 5th wheel? I’m trying to replace the standard square style land pad. Thanks

asked by: Trent

0

Expert Reply:

The Lippert Components 5th Wheel RV Landing Gear Foot Pad # LC314667 does not fit fifth wheel trailers it fits the landing gear on those trailers and you would only really need to know the manufacturer to be sure the pads will fit. If it's Lippert, these foot pads will absolutely work.

expert reply by: Kyle S

0

Answer 1

I went out to our warehouse and test fit some SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 and found that the 6" square SnapPads were a fit. If your 2022 Forest River Vibe travel trailer only has one #LC298707…

view full answer...

Answer 2

Glad to hear how pleased you are with the Lippert landing legs #LC179013 and #LC179014! I spoke to my contact at Lippert and he recommended a white lithium grease like #L11354 for the zerk fitting for the gears and a silicone based lubricant on the…

view full answer...

Answer 3

Hey Mark! The Roadmaster Reflex #RM62VR is reactive so it pushes back and helps you stay centered when you start to wander. The Exact Center #RM82RR is proactive so it actively works to keep you centered all the time. Most of our installers prefer…

view full answer...

Answer 4

Hey Darrell, thanks for reaching out! You're going to need the Roadmaster Reflex Steering Stabilizer #RM62VR for your 2025 Ford F-53 chassis. What Class A do you have?

view full answer...

Answer 5

Hey Matt, thanks for reaching out! I spoke with my contact at Lippert and that particular piece of the arm isn't available as a replacement part, so we'll need to get you setup with a whole new arm assembly. The correct replacement for your…

view full answer...

Answer 6

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…

view full answer...

Answer 7

The Lippert Components 5th Wheel RV Landing Gear Foot Pad - 9" Round #LC314667 is the original part for the Ground Control 2.0 system, but the Replacement Front Foot Pad for Lippert Components Ground Control 3.0 Leveling System #LC362486 will…

view full answer...

Answer 8

Yes, you'd need to hold the inner jack leg while you remove the bolt from the bottom when replacing the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System part #LC324269. In order to hold the inner jack leg, I recommend…

view full answer...

Answer 9

The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…

view full answer...

Replacement Landing Gear Foot Pad for Fifth Wheel Trailer

Product Page this Question was Asked From

Continue Researching