Which Grease Seal Does the Dexter Trailer Axle Beam Part # T3584F-EZ-8974 Use
Updated 06/21/2018 | Published 06/19/2018
Products Featured in This Question
Question:
What is the common grease seal? Or even better, what is the O.D. of the seal surface on the spindle? All other dimension requirements are noted in the specs, but I could not find this.
asked by: Gary
1
Helpful Expert Reply:
The Dexter Trailer Axle Beam part # T3584F-EZ-8974 that you referenced uses a 10-19 grease seal like part # RG06-050 which has a 1.719" inner diameter (ID) and a 2.565" outer diameter (OD).
expert reply by:
Conner L
1
Product Page this Question was Asked From
Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Looking for Pre-Greased 3,500 Idler Hub that is Galvanized for Trailer Axle
- Q&A: What Information Do You Need to Order a Correct Replacement Axle?
- Q&A: What Upgraded Equalizer Can I Use to Replace My 5 5/8" Long Standard Equalizer?
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Axle, Hubs, and Brakes for 2017 Jayco Jay Flight With Lippert Axle
- Article: How to Measure a Trailer Axle
- Q&A: What Are The Longest 3,500 lb Axle U-Bolts Available?
- Q&A: Does a Wheel's Width Matter When Buying a Tire?
- Q&A: Replacement 2,500 lbs - 3,500 lbs Axle w/a 86.5" Hub Face and a 68.5" Spring Center
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs