Installation of Curt Trailer Hitch # 13051 on 2001 Jeep Grand Cherokee
Updated 06/19/2018 | Published 06/18/2018
Products Featured in This Question
Question:
when installing on 2001 grandcherokee do you remove or retain rear most oem crossbar on frame? thanks
asked by: Tom
Helpful Expert Reply:
Curt Trailer Hitch Receiver # 13051 will not require removing any parts of your OEM crossbar or frame. It will simply have you remove some hardware for the tank shield and then clean out a weldnut that will be utilized. The tank shield will remain in place. You may need to use some spray lubricant and a brush like # 814092 to clean the weld nut to ensure proper fit prior to installing your hitch.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How To Install The Curt T-Connector Wiring Harness In A 2002 Jeep Grand Cherokee
- Article: Trailer Wiring Diagrams
- Q&A: Do You Need To Disconnect The Battery On A 2019 Cadillac Escalade While It Is Flat Towed
- Q&A: Is There A Factory Type Hitch For My 2004 Jeep Grand Cherokee?
- Q&A: Big Tex Trailer Ramp Replacement Springs
- Q&A: Replacement Hardware For Curt Trailer Hitch Receiver # 13051 For a 1999-2004 Jeep Grand Cherokee
- Q&A: Recommended 5.30-12 Tires With Load Rating Of D
- Article: Trailer Hitch Installation Tips
- Q&A: How to Prevent the Trailer Hitch from Scraping the Ground on a 2015 Subaru Legacy
- Article: How to Measure for Trailer Hitch Drop