Can 2 AWG Be Used on the Superwinch Winch 2 Go 4000
Updated 05/31/2018 | Published 05/29/2018
Products Featured in This Question
Question:
I have 2 guage power wires that i want to change the terminations on to plug directly into my Winch 2 go. Does part 2236 plug directly into the Winch 2 go power port same as part 1551? Thank you
asked by: Ivan
Expert Reply:
The Superwinch Winch 2 Go 4000 comes with 6 AWG. Therefore the correct quick-disconnect terminal would be part # BDW20047 which is rated for 6-10 AWG, not part # BDW20133 which is rated for 2-4 AWG. In order to use the quick-disconnect terminal rated for 2-4 AWG, you would also need to change out the wires in the box that run from the ring terminals on the winch to the quick-disconnect terminal on the back of the box.
Product Page this Question was Asked From
Bulldog Winch Quick-Connect Set for Powersports w/Dust Cover - 6 AWG
- Accessories and Parts
- Electric Winch
- Wiring
- Quick Connects
- 6 Gauge Wire
- Bulldog Winch
more information >
Continue Researching
- Q&A: Availability of Rubber Bumper For Horse Trailer Window
- Q&A: Trailer Jack for Use in Off Road Conditions
- Q&A: Winch Wiring it for 13,500 lb Winch to Rear of Vehicle
- Q&A: Gooseneck Hitch Adapter for Truck with Rails a B&W Patriot Hitch Fit
- Q&A: Replacement AirBag for Air Lift LoadLifter 5000 Part 5813
- Q&A: Differences Between Curt and Draw-Tite Trailer Hitches for 2020 Toyota Sienna
- Q&A: Will Curt Class III 2-Inch Hitch # C13105 Fit a 2008 Toyota Sienna Limited
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Lighting Requirements
- Article: Performance Chips and Modules
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Install E-Track in 3 Easy Steps