How to Install the On/Off Switch Panel for Atwood Gas and Electric Water Heaters Part # AT91230

Updated 05/08/2018 | Published 05/06/2018

Products Featured in This Question

Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters - White

(50)

$17.58

Female Spade Terminal Quick-Disconnect - 16-14 Gauge - Fully-Insulated PVC - Qty 1

(15)

$0.61

Deka Ring Terminal - Heat Shrink - 16-14 Gauge - 1/4" Ring ID - Nylon Insulation - Blue - Qty 1

(43)

$2.37

Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 5

(1148)

$5.36

Question:

Need to know how to hook switch up

asked by: Leann

Expert Reply:

I have attached the wiring diagram for the Replacement Double-Panel On/Off Switch for Atwood Gas and Electric Combination Water Heaters part # AT91230. The installation will be very simply with only 5 connections needed. There will be three terminals that go to the water heater (orange, blue, white), one terminal that goes to a 12 volt power source, and one terminal that goes to a ground. In order to make these connections I recommend using four of the Female Spade Terminal Quick-Disconnect part # DW01899-1, one of the Deka Heat Shrink Butt Connector Packs part # DW05743-5, and two of the Deka Ring Terminals part # DW05737-1. This will be everything you need to install the panel for the exception of common wire strippers.

This switch panel works with Atwood RV Water Heaters part # AT94022.

expert reply by: Conner L