LP11CB Compatibility with 24V System and 1251 Light Bulb
Updated 04/05/2018 | Published 04/04/2018
Question:
Can a 1251 light bulb which is a 24 volt double filament be used with the LP11CB.
asked by: Abe
0
Expert Reply:
The Optronics Snap-In License Plate light, # LP11CB uses the A-67 single filament bulb for 12V applications so the 1251 bulb would be the correct replacement to use in a 24V application with this housing based on my research.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Optronics Snap-In Mini License Plate Light - Incandescent - Round - Chrome Plated - Clear Lens
- Trailer Lights
- License Plate Lights
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 1-1/2 Inch Diameter
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Looking For Caliper To Replace Discontinued Tie Down Engineering 46802 Caliper
- Q&A: Can Truck with Firestone Ride Rite Air Bag Kit Installed be Lifted By Frame
- Q&A: What Gauge Wire Is Needed To Run Charge Line for Battery From Truck to Trailer
- Q&A: Correct Replacement for Dexter 13-10 Equalizer
- Q&A: Recommended 5th Wheel Hitch for MORyde Orbital Pin Box on 2019 Forest River Arctic Wolf
- Q&A: How Wide are A-Frame Trailer Couplers CA5400 and CA5100B
- Q&A: Tongue Angle of the A-Frame Coupler Part # CA5100B
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Lighting Requirements
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)