Is Drilling Required On The Curt Class I Trailer Hitch Receiver

Updated 03/18/2018 | Published 03/17/2018

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(336)

$172.71

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(7)

$71.95

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(334)

$36.80

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2273)

$49.70

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(35)

$56.56

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2932)

$2.69

Question:

I am looking at one of your hitches for my 2013 Accord and wanted to make sure there is no drilling required.

asked by: Andrew C

Expert Reply:

The Curt Trailer Hitch Receiver # C11681 is a bolt-on installation with no welding or drilling required.

To complete your towing setup, I recommend the Curt Class II Drawbar # C45521, # F-4 Pin and clip, and 2 inch Ball # A-82.

For trailer wiring, if you have LED tail lights use # C56173 and if you have traditional lights use # 118596. These will plug into your factory wiring and pull power directly from your vehicle battery.

I have the complete install video linked to this answer page.