Square Trailer Taillight Recommendation that Can have Longer Mounting Studs Used
Updated 03/12/2018 | Published 03/11/2018
Products Featured in This Question
Question:
Can the mounting bolts be replaced for longer hardware? The mounting point on my trailer is not flat, thin metal but square tubing.
asked by: Randall
0
Expert Reply:
You'll want the taillight part # C7493RTM if you are wanting a light that allows you to pick the length of the mounting hardware you'd need. There's no way to replace the studs of the light you mentioned.
I attached an install video for you to check out as well.
expert reply by:
Jameson C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Corresponding Passenger Side Light for Optronics Glolight Light # STL109RB
- Q&A: Do Bulbs of Gustafson RV Pancake Light # 277-000340 Ever Need to Be Replaced
- Q&A: LED Dome Light Recommendation for RV Interior With Adjustable Brightness
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: How to Choose a Trailer Hitch Coupler
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Article: Trailer Tire Sizing
- Q&A: How to Install a Trailer Tail Light with 3 Wires When Trailer Only Has 2 Wires
- Q&A: Replacement Passenger Side Taillight for the Malone LowMax, MicroSport, and MegaSport Trailer
- Q&A: How Do I Ground The White Wire When Assembling A Malone Kayak Trailer
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams