Recommended Tie-Downs for a Loaded Boat Weighing 5,000 lbs

Question

Question:

I need two boat tie down for the back of my boat, loaded boat wieghs about 5000 pounds and trailer weighs 2450. 4 ft is too short. I need like 6 ft or more in length.

asked by: Matt

0

Expert Reply:

I recommend using the CargoBuckle G3 Straps # IMF18800. These are ratcheting straps that have a very nice retractable feature for easy storage and to help keep things organized.

The G3 straps have a safe working load limit (WLL) of 1,167 lbs which will be enough for your 5,000 lbs boat since it will be resting on the trailer. The break strength rating is 3,500 lbs.

If you don't have a location to mount these then you need the Mounting Brackets # IMF16777 which have a weight capacity of 2,500 lbs.

expert reply by: Jon G

0

Answer 1

The pontoon trailer guide-ons only come in a set of 2 as that is all that is needed, although you can add more if you believe that it is necessary. That all just depends on how confident you are about staying on the right track once you have started…

view full answer...

Answer 2

Pontoon boats normally use guide-ons that mount in the center of the trailer, and even with the three pontoons on your aptly named Aqua Patio Tritoon having lifting strakes, the CE Smith Post-Style Guide-Ons for Pontoon Boat Trailers #CE27670 should…

view full answer...

Answer 3

Light truck tires (LT) are sometimes used in RV applications but generally not on utility trailers. Light truck tires are a type of passenger vehicle tire and as such they are not built with as thick of a sidewall as trailer tires. A thicker sidewall…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Ioan! So, I did some research into the 2021 Transit T-150 and I found some fun stuff... It sounds like it's actually pretty hit and miss as to whether or not there is any factory wiring for a brake controller on the van, even if it came…

view full answer...

Answer 6

I attached a diagram that shows how most 7-way rounds like the #PK11720 that you referenced will get wired up. As long as you got yours wired up correctly and your trailer taillights and brakes are functioning correctly that's all that should…

view full answer...

Answer 7

Yes, you can place the etrailer Horizontal E-Track #e25VR across your trailer from side to side. This will allow you to use the CargoSmart Motorcycle Wheel Chock #3481731 making it easier and safer to secure your bikes in your trailer. Be sure to use…

view full answer...

Answer 8

That is a good question, and you will need to use three backing plates for each 5 foot section of e-track, so the exact part you will need is the following: - etrailer E-Track Backing Plates w/ Hardware - Qty 3 #e46RR These will fit perfectly with…

view full answer...

Answer 9

Absolutely our Tongue Weight Scale #e99044 will work perfectly with your travel trailer! Our scale has a 2,000 lb capacity which you may think that a 5,000 lb trailer would be too much for our scale, but it's actually an ideal size trailer. What…

view full answer...

Answer 10

Without knowing what particular front leveling kit you have on your 2021 Ford F-150, I recommend the Timbren Front Suspension Enhancement System #TFF150G. However, even though this system fits with most standard leveling kits, we cannot confirm for…

view full answer...