Solution for Completing 12 Volt Power Circuit for Trailer Wiring in GM Truck
Updated 02/19/2018 | Published 02/18/2018
Question:
I have a 40 amp fuse in and I also have the red wire connected to the fuse box on post what Im still not getting any auxiliary power what should I do
asked by: Hunter S
0
Expert Reply:
Sounds like you have a mid 2000's GM truck and you're trying to install a brake and activate the 12 volt power source.
You still need to insert a 40 amp fuse in the correct slot in the power distribution box to complete the circuit. Check out the help article I attached below for more info on this as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Q&A: Suspension Enhancement Recommendation for 2003 Toyota Tundra with B and W Turnoverball
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer